Application Fields
For surely adhesion of the coating materials such as ceramic, granite ceramic, porcelain ceramic, marble to the external faces of the buildings up to the hight of 30 m.,
On the surfaces such as concrete, mortar, covering.

Technical Features
Aspect: 1st component: Grey powder ; 2nd component: White liquid
Application Temperature: +5 ºC / +35 ºC
Mixture Rate: 5,75 lt liquid / 25 kg powder
Pot Life: 1,5 hours
Joint Filling Period: After 2 days
Consumption: Average 5,5-6,5 kg / m² (Combined Method)
Package Powder: 25 kg. craft bag; Liquid: 5,75 lt. plastic tin
Shelf Life: (Powder and Liquid) In its unopened package in dry environment 12 months
Application Restrictions: Max 60 x 60 cm floor tiles up to the height of
15 m, max 40 x 40 cm floor tiles between the heights of 15-30 m
Flexibility: Very well
Open Waiting Period Straining Adhesion Resistance:
At least after 20 min. > 0.5 N/mm² (EN 1346)
Slipping: < 0.5 mm (EN 1308)
Adhesion Resistance: > 1 N/mm² (EN 1348)

Application Direction
Pay attention that the surface that been cured and strong.
Remove the residues that will prevent to adhere on the surface.
If there are defects on the application surface, straighten them with the TamirArt.
Mix it until there will not be any lump as pouring 25 kg. powder mortar over the liquid component slowly .(Use of low cyclical mixer is recommended for mixture.)
Rest the mortar for maturation for 5-10 minutes, mix it again before you start to apply.
Rake the mortar with a notched raked trowel that is suitable to the floor tile as spreading it on the surface.(See: Table of Rake Notch Size). Use the Combined Adhesion Method.
Adhere the floor tiles on the mortar that has been raked in 20 minutes.
Make the adhesion work towards the horizontal while working with big dimensional coating materials and do not start to the upper coat after the finished coat had its first resistance. Leave expansion joint once each 3,5 m. vertically and horizontally
Consume the prepared mortar in 1,5 hours.
Dispose the old and formed rind mortar.
Make the joint filling work after 2 days.
 

Warnings
Do not breathe the powder because of its is cement based, do not make it contact with skin and eye.
Use the product with the liquid component. Do not add water or any admixtures.
Store the liquid component between 5 °C - 23 °C, as it will not expose to the sunlight directly.
Store the liquid component in the dry environment with maximum 10 coat storing.
Above values had been given for 23 °C ± 2 and %50 ±5 humid environment conditions. These values may change according to the environmental conditions.