Application Fields
In spaces where there are sudden temperature changes (freezing-dissolution) such as cold stores and quick-freezing facilities,
For the external faces of furnaces,
In under heater systems,
For the terraces and garden arrangements,
On the surfaces such as concrete, plaster, covering,
For adhesion of the coating materials such as ground and wall ceramics, granite, clinker, decorative brick,
For the ceramic coatings on the old ceramics,
For ceramic applications on the hard surfaces such as plaster, dye.

Technical Features
Aspect: Grey colored powder
Application Temperature: +5 ºC / +35 ºC
Mixture Rate: 5,5-6 lt water / 25 kg powder
Pot Life: 3 hours
Joint Filling Period: On wall 24 hours, On ground after 2 days
Consumption Average: 4 - 5 kg / m²
Self Life: In its unopened package in dry environment 12 months
Package: 25 kg. craft bag
Flexibility: Good
Open Waiting Period Straining Adhesion Resistance:
At least after 30 min. > 0.5 N/mm² (EN 1346)
Slipping: < 0.5 mm (EN 1308)
Adhesion Resistance: > 1 N/mm² (EN 1348)

Application Direction
Pay attention that the surface that been cured and strong.
Remove the residues that will prevent to adhere on the surface.
If there are defects on the application surface, straighten them with the TamirArt or Mastar 10.
Mix it until there will not be any lump as pouring 25 kg. powder mortar over 5,5-6 lt. water.(Use of low cyclical mixer is recommended for mixture.)
Rest the mortar for maturation for 5-10 minutes, mix it again before you start to apply.
Rake the mortar with a notched raked trowel as spreading it on the surface. (See: Table of Notch Sizes)
Use of combined adhesion method is recommended for applications in spaces where the temperature changes are high.
Adhere the floor tiles on the mortar that has been raked in 20 minutes.
Consume the prepared mortar in 3 hours.
Dispose the old and formed rind mortar.
Make the joint filling work on wall for 24 hours, on ground after 2 days.

Warning
Do not breathe its powder because of its is cement based, do not make it contact with skin and eye.
Do not add any admixture that was not determined in the application guideline.
Store in a dry environment with maximum 10 coat storing.
Above values had been given for 23 °C ± 2 and %50 ±5 humid environment conditions. These values may change according to the environmental conditions.