Application Fields
In always wet areas such as pool,
On Basic and curtain walls,
In water depots, terraces, balconies,
On ths surfaces such as concrete, flaster, covering.

Tecnichal Features
Aspect: 1. component: Gray powder; 2. component: White liquid
Application Temperature: +5 ºC / +35 ºC
Mixture Rate: 5 lt liquid / 20 kg powder
Pot Life: 3 hours
Consumption: Average 1,5-2 kg / m² (for thickness of 1 mm)
Drying period: 3 days
Waiting period among layers: 5-6 hours
Period to take use: 1 week
Package: Powder:20 kg. craft bag; Liquid:5 lt. plastic tin
Shelf Life: (Powder and Liquid) In its unopened package in dry environment 12 months
Flexibility: Very Well

Application Guideline
Remove the residues that will prevent to be adhered.
Pay attention that the surface is strong and had been cured.
If there are any defects on the application surface, straighten then with TamirArt.
Coat the surface with Kalekim Astar before application.
Mix it until there will not be any lump as pouring 20 kg. mortar over the 5 lt. liquid component slowly (Use of low cyclical mixer is recommended for mixture.)
Rest the mortar for maturation for 5-10 minutes, mix it again before you start to apply.
Spread the prepaired mortar to the surface with brush or trowel as 2 layers. Wait between the layers for 5-6 hours depending on the temperature.
Make oval the corner combination areas in the application spaces and reinforce the mortar with netting
Consume the prepaired mortar in 3 hours. Dispose the old mortar.
Protect the applied surface against sun, rain and dust for 2 days and do not make application under direct sunlight.
If the application will be made on nearly dry mortar on surfaces, just make a local adjustment.
Cover the surfaces that are exposed to the pedestrian and load traffic with the coating material such as covering, ceramic because of it is a product that is applied as thin.
At least wait for 1 week before using or coating the applied surfaces.

Warnings
Do not breathe its powder because of its is cement based, do not make it contact with skin and eye.
Do not add any admixture into the powder mortar except its own liquid component.
Store the liquid component between +5 °C - 23 °C as it will not be exposed to the sun light.
Store the powder component in the dry environment with maximum 10 coat storings.
Above values had been given for 23 °C ± 2 temperature and %50 ±5 humid environment conditions. These values may change according to the environmental conditions.
Not used in the drinking water depots.