Application Fields
Specially on the low spreadings of the buildings (bathroom, toilet, washbasin)
On terraces and balconies.
In water depots,
On the surfaces such as concrete, plaster, covering.

Tecnichal Features
Aspect: White powder
Application Temperature: +5 ºC / +35 ºC
Mixture Rate: 5-5,5 lt water / 25 kg powder (Trowel application)
7,5-8 lt.water / 25 kg powder (Trowel Application)
Pot Life: 1 hour
Consumption: Average 2 kg / m² (for thickness of 1 mm)
Period to take use: 1 week
Application thickness: Basement, roof, terrace 2 mm.
Water depot 3 mm.
Package: 25 kg. craft bag
Shelf Life: In its unopened package in dry environment 12 months
Test Results
Adhesion resistance: > 1,50 N/mm²
Flexibility: Good

Application Direction
Remove the residues that will prevent to be clinged on the joint spaces and humidure.
Pay attention that the surface is strong and had been cured.
If there are any defects on the application surface, straighten them with TamirArt.
Soak the surface before starting to the application or use Kalekim Astar to have a better result.
Mix it until there will not be any lump as pouring 25 kg. powder mortar over the 5,5-5 lt. water slowly while applying with the trowel and 7,5-8 lt. water while applying with brush .(Use of low cyclical mixer is recommended for mixture.)
Spread the prepaired mortar to the surface with brush or trowel properly.
Rest the mortar for maturation for 5-10 minutes, mix it again before you start to apply.
Make oval the corner combination areas in the application spaces and reinforce the mortar with netting
Consume the prepaired mortar in 1 hour. Dispose the old mortar.
Wait for 5-6 hours for 2 layered applications with brush depending on the temperature among the floors. An application thickness of total 2-3 mm. will be enough. This thickness can be obtained with one layered application with the trowel.
Protect the applied surface against sun, rain and dust for 2 days.
If the application will be made on nearly dry mortar on surfaces, just make a local adjustment.
Cover the surfaces that are exposed to the pedestrian and load traffic with the coating material such as covering, ceramic because of it is a product that is applied as thin.
At least wait for 1 week before using or coating the applied surfaces.

Warnings
Do not breathe the powder because of its is cement based, do not make it contact with skin and eye.
Do not add any admixtures that were not determined in the application guideline.
Store it in the dry environment with maximum 10 coat storings.
Above values had been given for 23 °C ± 2 temperature and %50 ±5 humid environment conditions. These values may change according to the environmental conditions.
Not used in drinking water depots.