

Home	Plasters and Final Decorative Coatings	Paints	Construction Chemicals	Russian

FUGA GROUTING MORTAR (1-6 mm)

Cement based, single componented joint filling material that obtains smooth surface, includes the chemical admixtures that increase the product's performance, workability, cracking resistance, colour permenance.
Ready to use with its rich colour selection.
Resistantent against paling, does not crack and the dye do not vomit.

TSEK and EN 13888 certificated.

Application Fields
In the joint spaces of the coating materials such as the ground and wall ceramics, marble, natural stone, marble, natural stone between 1-6 mm.

Technical Features
Appearence: White and colourfull very fine powder
Application Temperature: +5 ºC / +35 ºC
Mixture Rate: 6-6,6 lt. water / 20 kg powder
1,5-1,6 lt water / 5 kg powder
Pot Life: 1 hour
Period to take use: On wall 24 hours, On ground after 2 days
Consumption: See. Consumption table
Package: 20 kg. craft bag and 5 kg. polyethilene bag
Shelf Life: In its unopened package in dry environment 12 months
Test Results
Breaking resistance: >4 N/mm²
Pressing resistance: >15 N/mm²
Flexibility: Medium

Application Guideline
Remove the residues that will prevent to be clinged on the joint spaces.
Mix it until there will not be any lump as pouring 25 kg. powder mortar over the 6-6,5 lt. water slowly .(Use of low cyclical mixer is recommended for mixture.)
Rest the mortar for maturation for 10 minutes, mix it again before you start to apply.
Fill the mortar into the joint soaces with a rubber trowel with crosswise actions as spreading it on the surface and take the residuces as grazing
Clean the surface with a humid sponge after 20-30 minutes.
Polish the surface as cleaning with a dry cloth after it dried.
Consume the prepaired mortar in 1 hour. Dispose the old mortar.
Pay attention to the water rate that will be added into the powder mortar, avoid from application in emulsion form. Application in emulsion form will cause to the crackings, collapses, easy abrasions, chalkings and colour defects.
The space can be started to be used in 24-48 hours after the joint application.
Use the joint filling material of FugaFlex for the floor tiles with low absorbtion of water such as granite ceramic.

Warnings
Do not breathe its powder because of its is cement based, do not make it contact with skin and eye.
Do not add any admixtures that were not determined in the application guideline.
Store the craft box product in the dry environment with maximum 10 coat storings.
Above values had been given for 23 °C ± 2 temperature and %50 ±5 humid environment conditions. These values may change according to the environmental conditions.