MIKRO DREWA

DESCRIPTION

 Syntetic resin emulsion based, containing small natural coloured marble chips, applied by steel trowel, fine ready mixed interior and exterior plaster.

  PROPERTIES

* Decorative with its natural texture and 24 colors

* highly resistant to UV rays, rain, heat and frost. thus retains its original properties for years without cracking, bilistering and fading

* Alkali resistant therefore unsaponifiable

* Water resistant

* Solvent-free, water thinnabel, ecologically compatible and low odour

* Tough and insensitive to shock and impact

* Adheres firmly to all types of masonry surfaces

* Helps buildings to breathe with its high water vapour permeability

APPLICATION FIELDS

Decorative coating for exterior and interior use on mineral surfaces (concrete, gas concrete, mortar etc)

APPLICATION METHOD

1- The subsrate must be dry, clean and free from all materials that may prevent good adhesion. All water insulation precautions related with the building must have been taken beforehand.

2- The surfaces on which MIKRO DREWA will be applied must be previously primed with special plaster primers of Kalecolor, Uni-Astar or Silastar, It is recommended to use primer in the color shade of MIKRO DREWA to be applied.

3- MIKRO DREWA application should begin one day after the primer application. First, it is transferrede to a large container and mixed thoroughly, Then, evenly spread on surface by a steel trowel. Nothing must be added to MIKRO DREWA beside the clean water that is necessary to add till it regains its application visconisty in cases when it has lost from its water content for some reasons. Clean the tools after use with water.

CONSUMPTION

The consuption of MIKRO DREWA is 2.5 to 2.9 kg/m2

PACKAGING

MIKRO DREWA is avaible only in 25 kgs pails.

Please Note:

* Like other dispersion based materials, MIKRO DREWA should not be applied under glaring sun, strong wind, fog, relative humidy, imminent rain or frost.

* Beign natural materials, marble chips used in MIKRO DREWA may occasionally cause slight differences of color in the finished coating. It is therefore recommended to use only material marked with identical batch numbers or, if utilizing material from different batches, the entire quantity needed should therefore be mixed in advance.

* To avoid lapping on large surfaces, care should be taken to have a sufficient number of hands on the job and to apply the material wet-on-wet without interruption.

* Not suitable for application on horizontal surfaces exposed to rain and or moisture.

* Minimum temperature for application is +5 C for subrate, material and air.